Instructions
Application Wet & Forget Shower takes the hard work out of cleaning. No scrubbing or wiping needed—just spray on fixtures, shower curtains, enclosures, shower glass, tiles and tubs, once a week, after the last shower of the day. For best results leave on surface 8-12 hours (but no more than 24 hours). Rinse shower base or tub thoroughly before re-entering. Wet & Forget Shower’s cleaning formula goes to work on contact cleaning. The next day, just rinse the surfaces before or during your shower. Mold And Mildew Stains: Cleans mold and mildew stains on hard non-porous surfaces. When rinsing, a wipe down may be necessary. Will not remove mold and mildew stains from caulk and grout. Hard Water / Mineral Deposits: In some cases, may not remove hard water / calcium deposits (water spotting). Once cleaned dark tiles may highlight calcium deposits. Clean hard water stains prior to or after using Wet & Forget Shower. Tough-To-Reach Areas Wet & Forget Shower comes equipped with a remote-spray trigger that allows you to pivot the trigger into any position to get to those tough-to-reach areas. Turn the sprayer upside-down and get the same product flow as the upright position. The Wet & Forget Shower trigger sprayer can spray up to 10 feet allowing you to clean those not so easy-to-reach areas. Starting With a Dirty Shower If you’re starting with a dirty shower, no problem! Wet & Forget Shower goes to work on contact getting rid of soap scum, grime, oils, mold and mildew stains. Simply apply Wet & Forget Shower after the last shower of the day and let it sit until the next day. Rinse the shower and, if necessary, give it a quick wipe-down. If there are still signs of shower grime, repeat the same routine daily until clean. No scrubbing required! Once you achieve a clean shower, you’ll only need to apply Wet & Forget Shower one time per week to maintain a clean, fresh shower.
by admin
Great product.